NEW PRODUCT INNOVATIONS Cam Units

150 subject to alterations AERIAL CAM UNIT FCC-HV 2016.24. ASSEMBLY IN THE TOOL Series 2016.24. cam units are designed in a way that the screws and pins for positioning and securing the cam slide unit components in the tool are accessible in the open position of the cam unit. This access can be restricted or completely prevented by constructions on the cam slide unit working surface. In these cases, the populated cam unit can be disassembled / assembled by dismantling the clamp: STEP 1  Remove the gas spring before disas- sembling the cam unit. Within the tool, the corresponding cons- tructional clearances must be taken into account at the rear. Caution The gas spring may only be removed if the spring itself is released. After removing the stop plate for the gas spring, note that there is a risk of crushing between the cam slider and the cam unit base due to independent movement of the cam slider. STEP 2  Unfasten and dismantle the left and right guide clamps. No removal of positioning pins required! Within the tool, the corresponding con- structional clearances must be provided on the sides. STEP 3  Lift the populated cam slide unit upwards. The cam unit base can remain in the upper die