F364 CONCERTINA SHROUD FOR GAS SPRINGS Description: The concertina shroud protects the piston rod of the gas spring against negative influences, such as e.g.: ● Dirt penetration ● Damage to the surface of the piston rod ● Adhesion of dirt particles ● Drawing in of oil and/or emulsion The fastening of the folding bellows is internal (on the cylinder tube side) and does not have an interference contour, for example, due to externally attached pipe clamps. In this way, the gas spring can be attached and installed in the tool without limitations. The concertina shroud for gas springs prolongs the lifetime of the gas springs under rough operating conditions. Technical data Material : Concertina shroud: CSM-Rubber 65 ±3 Shore A Washer: Steel burnished Ring: stainless Steel Temperature range: 0-90 °C Chemical resistance Acids: very good Alkalines: very good Solvent: adequate Weather resistance Sun light (UV): good Ozone: very good Water: adequate Oil resistance: mineral: good synthetic: adequate Delivery: Concertina shroud incl. rotatable disk and countersunk screw. Custom dimensions/materials available on request. Mounting examples: More mounting examples for gas springs see page „Mounting directions for gas springs” fastened with 2480.007./008. fastened with 2480.055./057./064. fastened with 2480.044./045./047. installed loose in the bore Screw mounted at the base with 2480.011.
RkJQdWJsaXNoZXIy MTIwNzY0