C50 a1 b3 b2 a2 e1 e2 b1 c 2140.16. h b1 e1 b3 d2 e2 d1 b2 c l a1 a2 2140.10. Material: Heat-treated steel, painted Note: Holding and contact surfaces are plane-parallel. High clamping forces can be achieved by using high-strength screws conforming to DIN 787. The dimensions of the holding strap should be matched to the strength of the bolts. Supplied without clamping bolt, suitable clamping bolts: 2140.30. 2140.16.26.250: c = 35 mm, does not conform to DIN 2140.16. Clamp, straight, DIN 6314 Order No a1 a2 b1 b2 b3 c e1 e2 2140.16.09.060 8 9 60 25 10 12 13 22 2140.16.11.080 10 11 80 30 12 15 15 30 2140.16.14.100 12 14 14 100 40 14 20 21 40 2140.16.14.125 12 14 14 125 40 14 20 21 50 2140.16.18.125 16 18 18 125 50 18 25 26 45 2140.16.18.160 16 18 18 160 50 18 25 26 65 2140.16.22.160 20 22 22 160 60 22 30 30 60 2140.16.22.200 20 22 22 200 60 22 30 30 80 2140.16.26.200 24 26 200 70 26 30 35 80 2140.16.26.250 24 26 250 70 26 35 35 105 Material: Heat-treated steel, painted Note: Supplied with setscrew and clamping bolt for T grooves conforming to DIN 787 8.8 with nut and washer. 2140.10. Clamp, straight, with setscrew Clamping bolt Order No a1 a2 b1 b2 b3 c d1, 2 e1 e2 h* d1 x a1 x l 2140.10.10 10 11 80 30 12 15 M10 15 30 8 - 32 M10x10x80 2140.10.12 12 14 100 40 14 20 M12 21 40 10 - 40 M12x12x100 2140.10.14 14 14 100 40 14 20 M12 21 40 10 - 38 M12x14x100 2140.10.16 16 18 125 50 18 25 M16 26 45 13 - 49 M16x16x125 2140.10.18 18 18 125 50 18 25 M16 26 45 13 - 46 M16x18x1125 2140.10.20 20 22 160 60 22 30 M20 30 60 16 - 65 M20x20x160 2140.10.22 22 22 160 60 22 30 M20 30 60 16 - 65 M20x20x160 *Clamping height depends on the groove depth CLAMP, STRAIGHT, DIN 6314 CLAMP, STRAIGHT, WITH SETSCREW
RkJQdWJsaXNoZXIy MTIwNzY0