D321 1 d H5 m5 3 d R 10 Z d 1 3 c 1 d 3 d H5 js4R 10 Z 10 Z R 1 d H5 js4 3 d 3 d 10 Z R 1 d 210.39. 16 28+0,009 20 32+0,011 25 40+0,011 32 50+0,011 40 63+0,013 50 80+0,013 63 90+0,015 202.60. 19 25+0,009 33 25 30+0,009 33 32 36+0,011 38 40 46+0,011 38 2051.32. 8 13,7+0,008 11/12 22+0,009 15/16 28+0,009 19/20 32+0,011 24/25 40+0,011 30/32 48+0,011 38/40 58+0,013 48/50 70+0,013 60/63 85+0,015 80 95,7+0,015 206.54. 2061.44. / 2061.47. 3 7+0,009 8 18+0,008 4 8+0,009 10 22+0,009 5 10+0,009 11/12 22+0,009 6 11+0,011 15/16 28+0,009 8 14+0,011 19/20 32+0,011 24/25 40+0,011 30/32 48+0,011 38/40 58+0,013 48/50 70+0,013 60/63 85+0,015 80 105+0,015 ASSEMBLY OF GUIDE ELEMENTS DIMENSIONAL REQUIREMENTS AND TOLERANCES 210.39. Retaining bush, similar AFNOR transition fit 202.60. Demountable guide pillar with centre fixing transition fit 2051.32. Guide bush, sintered ferrite carbonitrided with long-term lubricationDIN 9831 / ISO 9448-2 Slip-Fit Bonding* 206.54. 2061.44./2061.47. Guide bush for ball bearing DIN 9831 / ISO 9448-3 Slip-Fit Bonding* Pillar-Ø d1 Retaining bore d 3 H5 Pillar-Ø d1 Retaining bore d3 H5 Plate thickness c3 –1 *Slip-Fit Bonding: The glue-line gap must not be smaller than 0,005 mm, or the adhesive will be wiped off the contact surfaces upon fitment. This would result in an unreliable bond. The available component tolerances do not always result in the minimum glue-line gap. This fact has to be born in mind when machining receiving bores, mor alternatively corrections can be made on the assembly bench. Pillar-Ø d 1 Retaining bore d 3 H5 Pillar-Ø d1 Retaining bore d3 H6 Pillar-Ø d1 Retaining bore d3 H5
RkJQdWJsaXNoZXIy MTIwNzY0