LIDECO Standard Parts 07/2022

F365 1 1 2480.00.30.01 2 4 2480.00.24.01 3 4 2480.00.23.□□.□□□ 4 4 2480.00.24.02 INSTRUCTIONS FOR HOSE ASSEMBLY MOUNTING ARRANGEMENT FOR GAS SPRINGS IN THE MINIMESS SYSTEM Refer to DIN 20066 for further details on installing hose connections. Attention! Any modifications whatsoever to the product are prohibited. For further information refer to the FIBRO Gas Spring Catalogue, visit www.fibro.com or contact your FIBRO agent. 2480. Connection 1: Direct connection for group Never exceed the maximum pressures and temperatures for the hoses. Ensure that all hoses and adaptors are perfectly clean prior to assembly. The sheathing of the hoses must be perforated so that they can be used for pressurised gas. We recommend the use of the 24° cone hose system if pressure vessels are used to avoid restricting gas flow. Follow the instructions below to ensure functionality and maximum service life for the hose connection: The longitudinal marking on the hose must not be twisted during assembly. Use only hose fittings which prevent kinks forming in the hose. Any bends in the hose must always have the recommended minimum radius, as detailed in the catalogue. The hose must be connected correctly to avoid mechanical damage. Select a hose length to provide a certain amount of play. Function: Each spring is connected via a direct wire to the control fittings. They are not interconnected and form a pressure zone. See control fittings 2480.00.30 Note: When installing gas springs in the system always remove the valve from the gas spring. Item No. Term Quantity Order No. Note Control fitting Optionally with diaphragm pressure switch 2480.00.30.02 Gauging coupling Gauging hose Type of connection and length as required Gauging coupling