H13 METAL ADHESIVE FIBROLIT® MK RELEASE AGENT ACMOS RELEASE AGENT FIBROLIT® TW Description: Silicon-free release agent as a spray. Application during casting for sliding parts such as gliding pins, punches etc. with 280.02 FIBROLIT®-ZWO epoxy casting resin or 280.08 FIBROFIX®-SECHS tool casting resin. Spray on release agent thinly and evenly from a distance of 20 to 30 cm. A smooth surface is achieved by rubbing with a soft cloth. Aerosol spray can, 400 ml 280.822405 Release agent ACMOS Description: Two-component adhesive based on epoxy resin. Mixing ratio of the resin and hardener is 2:1 by weight. The adhesive should ideally be applied with a brush to the degreased parts to be joined. Rough surfaces improve adhesion of the metal adhesive. After only 6.5 h, the adhesive reaches a tensile shear strength of 30 N/mm2. The final strength is achieved after approx. 24 h. The metal adhesive is suitable for an adhesion gap of 0.6 - 0.7 mm. Adhered bushings retain their geometric roundness and accuracy to gauge via adhesion. Despatch packaging contains: 1 can of resin, 217 ml 1 can of hardener, 119 ml 281.01 Metal adhesive FIBROLIT® MK Description: Wax-based release agent for further guide clearance. Application during casting of sliding parts such as gliding pins, punches etc. with 280.02 FIBROLIT®-ZWO epoxy casting resin or 280.08 FIBROFIX®-SECHS tool casting resin. Particularly suitable for rougher mould surfaces. Quick-drying and easily polishable. Apply the release agent with a cloth and rub in well. Repeated application will produce increased clearance between the part and the resin. Can, 500 ml 280.27 Release agent FIBROLIT® TW
RkJQdWJsaXNoZXIy MTIwNzY0